Search:

I live in Ken Caryl, so a little distance away but not to far. What color is your car?

Great to know there is another Noble in CO. We'll all have to get together sometime.

Willy is the best and will take care of you.

Ken

Installed catch can. A few brass fittings took care of everything.

There is no hole to plug in the sump where the hose from the bottom of the separator goes into. I just need to find the same...

There is some type of angled plate inside that has a bunch of holes drilled in it. It's made out of aluminum and is really well made. Why did I wait so long to install it.:(

12838

The t hose from the two valve covers will still plug into it. It will work exactly like the stock separator except there will be no hose dumping gunk into the oil sump from the separator.

I...

Getting rid of current oil separator set-up. No idea why they have it dumping into the sump. Will replace with this nice aluminum one I've had sitting around for 2 years12837. Just drain it when...

Was going to the track all cleaned and shiny, loaded in the trailer went to strap down and saw this line hanging out. There goes the weekend.

Put up on my lift and here is what I saw. Turned...

Willy thought it was a belt and had me spray brake cleaner on the belts, they chirped like crazy. I thought I would have to tighten them but now that it's warmer, no chirping. I re-gaped the plugs...

Chirping was a loose belt, thanks for the diagnose Willy. Car ran great today, no boost break up.

Thanks Troy. Do you have a picture of what connector should be where?

On another note, I'll probably be going to the dyno for an hour next week and I'll have you look at everything remotely like...

I guess the only way to figure it out is to look at every little hose connection. Would it more likely be a pop off valve or something like that?

Thanks,

Ken

I want to start tracking again and did a leak down test to make sure everything was good. They said all were good, between 3-4% tops. The next time I started the engine, I hear this bird chirping...

Yes, you sold me the replacement radiator that is working fine and not leaking.

I found my leak, it was at the top of the tank, bottom side, passenger side. It took a while to start leaking, usually a 20-30 minute drive. I could see where it would run down and then drip onto...

My leak was from the same area. There was a bunch of fluid sitting in the belly pan at the passenger side.

It's a royal PIA. You've also got to remove the power steering and oil cooler also. I decided to pay to have it done. Labor was more then the new radiator from Willy. Mechanics couldn't believe...

I believe Willy has these.

Correct

Sounds good with me. I bought the same brake bias adjuster you have. I have my front clam off and it would be easy to put it on now with everything out of the way. Busy this weekend, lets talk...

Shore ratings https://www.smooth-on.com/page/durometer-shore-hardness-scale/

Willy and Doug are impressive.

I just looked and my dark blue bushings with a 92 shore rating are still in great shape.

Well, I don't think I'll buy one of those. I hope when I get into it, it's a hose and not the radiator itself . . .wishful thinking on my part.

Thanks for the responses.

Yes I do track my car. I have no idea why they didn't allow removal of the belly pan like you can in the rear. Just another 100 bolts to remove. I will check with...

Southwest Lotus has them for 395 pounds and Pro Alloy has them for 495 pounds. Pro Alloy says theirs's is an upgraded 50 mm thick one. Both are out of the UK.

After doing a thread search, it looks like Ron Davis has a direct replacement with a better then stock radiator. What have others used or is this the best replacement if a new one is needed which is...