Noble M12 DIY projects

[cooch8c]

Starting the engine install

[cooch8c]

It's been awhile. I'm still in the middle of the Ecoboost swap. I wanted to share a tool for putting a bead into soft metal. I was shorting up the tunnel pipes and needed to put a bead into them. I got the tool off eBay and can post a link if needed. Also 90% done with the electric power steering install and will share that soon.

[Godzilla]

I see Nitto NT01s on your car. I run them also and love them. Mine do not have the white logos, is there a special order for that?

[cooch8c]

Godzilla,
Here is the link for the tire decals I used.
https://tredwear.com/product/racing-...re-letter-kit/

[cooch8c]

Here is the EPS installedalso add part number for factory replacement WURTH coolant hose clamps

[gafernandez]

Looks great, I used the one out of the mini that way i could use a remote reservoir.
I was able to put the pump inside the cavity under the a/c and the reservoir were the windshield washer bottle goes

[cooch8c]

Thanks Will,
My wife’s mini has that ZF pump and also uses a electric fan.

I’m hoping the two CAN wires that Ford supplies with the Ecoboost harness will work to control pump speed

[gafernandez]

okay the mini uses a pressure sensor to control speed

[cooch8c]

Replace my M400 seat belt guides. Thicker plastic, better lock together than one on the right

[Driven]

Looks great, I used the one out of the mini that way i could use a remote reservoir.
I was able to put the pump inside the cavity under the a/c and the reservoir were the windshield washer bottle goes

Care to walk thru how you did it?

I have the Toyota EHPS installed, but it's too big to fit in the front of the car.

I read the mini one gets a signal from the alternator, but haven't heard anyone getting it to work first hand.