Price: $65,000
Miles: 22,xxx (car in storage now, can get exact mileage on request)
Location: Des Moines, IA

I purchased this car from tcal007 back in May 2014. I raced it once that summer, and then started a family and combined with job changesI just don't have time to enjoy the car anymore. This past summer I only drove the car to and from work a couple days a week, plus a couple car shows. The car is in great shape mechanically, I would have no hesitation to race it again if I had the time. I have spent over $20k on the car during my ownership.

New motor in 2016 - all work done by Willy
Converted to Ford ECU and Rossion engine harness - Willy tuned, running 16psi track-safe tune now
BorgWarner EFR 6258 turbos, each capable of 44lb/min airflow, nearly 50% more than the stock M400 turbos, and quicker spooling than stock. This setup could easily make over 600whp with the right fuel. See below dyno sheet showing 590whp on a Mustang dyno (power keeps climbing to redline, this was before tuning was complete and lowered boost to 16psi). Integrated recirculation valves and wastegates are built into the turbos.
Turbo blankets
Turbohoses piping for turbos
Full 3" vband exhaust - built by Willy
Custom built fuel cell with internal scavenger pump
Upgraded Bosch fuel pump & fuel lines
60# fuel injectors
Larger 1G intercooler with two thermostatically adjustable Zirgo Fans which have a computer controller in the cockpit
Spal fan controller for oil cooler fan, you can activate with switch manually if wanted
Custom built Fire Suppressant system with release handle next to the driver seat, this system covers the cockpit and engine compartment
Upgraded 5 point safety harness system from Race Product
Upgraded rear view mirror with outside temp and Home-link (garage door opener)
Upgraded front brake cooling ducts including custom hoses and fittings
Remote battery access plug
New Optima red top battery
Spal programmable shift light mounted on the steering wheel
High temp throttle cable
Custom Stainless Steel shielding package
Ceramic coating on firewall and inter-cooler box
Unsprung AP racing clutch, throw out bearing and cap
Upgraded front axles
Fedoro 2500 and Carbotech XP10 brake pads, have a few sets
Ron Davis aluminum radiator installed with rubber grommets (thicker than stock)
Blocked off the rear tunnel
Front tunnel cooling mod
6000k 55W HID's installed
Tinted windows
Momo steering wheel
Difflow diffuser
Black powder coated wheels
Clear bra on front and sides
Nitto NT01 tires, about 50% tread left. Also including a set of slightly used Hoosiers

The bad:
Few scratches and scuffs on the clear bra (paint underneath is fine). At this point it would probably look better if some of the pieces were replaced.
Small tear in shifter boot fabric
Paint scuffs at the bottom of rear clam where it hinges, I'm assuming from being set down when removed from the car.
Couple stone ships on the wing end pieces

I have documentation and receipts for all the work done, all in a huge binder. I also have a binder with the build manual printed. You can send me a PM or email me at ashanson at gmail dot com. Let me know if you'd like additional photos of anything specific.